Seedlings for sugarcane sugarcane sugarcane sugarcane species species 
 Sugarcane, the raw material is sugar. The bagasse fiber spinning can be prepared by the weaving process can be made cane panels, paper, also refining alcohol, sugar, formaldehyde, plastic and so on. In recent years, mainly the introduction of plant species TSC Series No. 20,22. 
 To capture high-yielding sugar cane, must use robust growth, bud eye full, sugar cane tail section of about 70 cm long segment Shaotou for seedlings. 
 Shaotou selected section after the cut cane species, the best dual-shoots. As a homogeneous two-shoots stout, and promote each other, there is no budding has the strength of the points, so sprouting full, homogeneous, uniform, strong, easily won the high yield. And the shoots grow with, because sugar cane has the characteristics of apical dominance, so the shoots to the top of the bud will be the first out, and produce auxin. The lower section of the seedlings used, due to the top of the auxin effects of inhibition of lower sugarcane buds, resulting in non-uniform germination, growth is not uniform, as well as shading the disadvantages of high-yielding hard won. Single shoots is not good. Because both ends of a single incision in the bud sprouts, vulnerable to the impact of drought and pest against water loss, and stem the leakage of the incision and more nutrients, seedling emergence is not enough thick. So cut sugar cane in the species, be sure to chop the remaining two-shoots (that is to chop the remaining two sugarcane section) as well. And species to the attention of the cut, the lower section of sugarcane buds to stay between the two-thirds of the upper section between the left third. This is because sugar cane nutrients needed for growth, are up from the lower part of the Ministry of transport, each of the nutrients required for sugarcane shoots and water main between the buds of the lower section of the supply, so leave room for two thirds of the section sugarcane bud germination can guarantee adequate nutrients and water. Between the left upper section of one-third of sugarcane buds to protect against harmful bacteria. And in the cut types, the first growth point to the following young about 7 cm long part of chopped, and then two sections cut to the specifications of a species. Cut types of requirements: the chopper, to Lee and thin plate to be flat and hard, the force should be uniform and precision, incision should be smooth, bud, but not tear the skin to complete, and the old, in three sections separated stacked tender for soaking and disinfection, respectively, were primed and nursery, planting. This is even stronger for the cultivation of sugarcane seedlings are very favorable. A large number of species of sugarcane sugarcane sugarcane for sugar cane sugar cane seedlings. Tel: